Mylex AcceleRAID 250 Informations techniques télécharger pdf (Page 31)

First-Time Configuration

Manual No. 775029 1-23

☞ To save the array you’ve set up, press Enter with Save Array

selected.

A Notice is displayed at this point as shown in Figure 1-21.

Figure 1-21. Define Logical Drives or Return to Disk Array Set-Up

“Do you want to build additional arrays at this time?”

If you want to set up additional arrays, it is convenient to do so at this time

before logical drives are defined.

☛ Note

If you want to take advantage of “spanning” your

configuration across multiple arrays, you must enable

spanning FIRST, build the individual arrays, then

create logical drives that can make use of the spanned

capacity available. See the section “How Do I Make

Use of the Spanning Feature?” on page 2-54 in

Chapter 2 for more complete information about this

option.

If you plan on only one array, or if you’d prefer to define logical drives

before building any additional arrays, you should move on to define logical

drives at this time.

☞ To build additional disk arrays, use the arrow key if necessary

to select No, then press Enter. Repeat the steps described in

“Build Disk Arrays.”

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 249 250

Pas de commentaire

Mylex AcceleRAID 250 Informations techniques Page 31