Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guide d'installation télécharger pdf (Page 51)

Controller Start-up

Manual No. 775020 3-7

In Case of Problems

If problems are encountered during start-up, check the following:

• Check SCSI cabling for loose connections, pin mismatches (make sure

pin 1 on the cable matches pin 1 on the connector), bent pins, and

damaged or crossed cables.

• Check cable length. This includes internal bus lengths in enclosures.

• Check termination.

• Check SCSI IDs on all drives.

• Remove the system cover, power ON the system and observe the LEDs

(see Figure 3-1).

• Be sure the U1 light goes out after system is booted.

• Be sure the SE or LVD is lighted appropriately, see the table excerpt

following Figure 3-1 on the next page.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 101 102

Pas de commentaire

Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guide d'installation Page 51